Ask is moving to Stack Overflow and Serverfault.com! Please use the "opendaylight" tag on either of these sites. This site is now in Read-Only mode

Revision history [back]

click to hide/show revision 1
initial version

I think you built the project based on master. Please try to checkout stable/beryllium and give it a try. The following steps should give a success.

git clone https://git.opendaylight.org/gerrit/l2switch git checkout stable/beryllium mvn clean install -DskipTests

Please let me know any further questions.

I think you built the project based on master. Please try to checkout stable/beryllium and give it a try. The following steps should give a success.

git clone https://git.opendaylight.org/gerrit/l2switch https://git.opendaylight.org/gerrit/l2switch

git checkout stable/beryllium stable/beryllium

mvn clean install -DskipTests

Please let me know any further questions.

I think you built the project based on master. Please try to checkout stable/beryllium and give it a try. The following steps should give a success.

git clone https://git.opendaylight.org/gerrit/l2switch

git checkout stable/beryllium

mvn clean install -DskipTests

Please let me know any further questions.These are the steps that i follow in order:-

git clone https://git.opendaylight.org/gerrit/l2switch

cd l2switch

git checkout stable/beryllium

mvn clean install -DskipTests

cd distribution/karaf/target/assembly/bin

./karaf debug

feature:install odl-l2switch-all

then in a new terminal start mininet with following command (OF13, 1 switch - you can change parameters as needed)

sudo mn --controller=remote,ip= --switch=ovsk,protocols=OpenFlow13 --topo=linear,1 it shows connnected to controller

You can checkout who is listening on ports by using command "netstat -an"